Access VIRUS|POWERCORE Especificaciones Pagina 93

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 194
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 92
ACCESS VIRUS RACK XL OS5 93
Chorus
PDF VERSION - RESTRICTIONS APPLY
The FEEDBACK parameter is bipolar; positive
or negative feedback values let you dial in dif-
ferent phaser characteristics.
01111111111111111112
1 PHASER
Feedback +0≤
61111111111111111154
STAGES
Use STAGES (1-6) to select the number of
phaser stages or filter poles. This determines
directly the number of filter notches and peaks
in the phaser signal.
01111111111111111112
1 PHASER
Stages 4≤
61111111111111111154
SPREAD
Use SPREAD to increase or decrease the dis-
tance between the notches and peaks in the
frequency spectrum. In other words, here you
can adjust bandwidth of the phaser effect.
01111111111111111112
1 PHASER
Spread 127≤
61111111111111111154
CHORUS
DIR/EFF
Controls the balance of volume levels between
the direct signal and the Chorus signal: At a val-
ue of 0, only the direct signal is audible, at a val-
ue of 127, only the Chorus output signal is
audible. The values between these two ex-
tremes determine the mix of the two signals.
The pure chorus signal is created by a delay
(CHORUS delay) and a pitch modulation of the
chorus’ on-board LFOs (CHORUS Rate and
Depth). Not until the direct or dry signal (CHO-
RUS Dir/Eff) is mixed to the wet signal is the
typical chorus effect generated.
01111111111111111112
1 CHORUS
Dir/Efx 20≤
61111111111111111154
SHAPE
Determines the waveshape of the chorus LFO.
You can select from among 6 waveshapes.
01111111111111111112
1 CHORUS
Shape Triangle≤
61111111111111111154
Vista de pagina 92
1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 193 194

Comentarios a estos manuales

Sin comentarios