
PARAMETER REFERENCE MANUAL12
Key Follow •
-64 to +31, Norm, +33 to +63: How much the pitch of oscillator 1 follows the keyboard (i.e. MIDI note
number). Press both VALUE buttons at the same time for normal tuning (Norm).
Balance •
-64 to +63: Adjusts the relative levels of oscillator 1 and oscillator 2 (including FM), whereby -64 is oscillator
1 only and +63 is oscillator 2 only. Note that this parameter is mirrored in the oscillator 2 menu. Modulation
destination “Osc Balance”.
Oscillator 1 (HyperSaw)
This information only applies to oscillator 1 in HyperSaw mode
Mode •
Classic, HyperSaw, WaveTable: Selects the basic type of oscillator.
Density •
1.0 to 9.0: The number of sawtooth waves used. The volumes are cross-faded for completely smooth tran-
sitions. Modulation destination “Osc1 Shape“.
Spread •
0 to 127: Detuning of individual sawtooth waves within the HyperSaw. Modulation destination “Osc1
PulseWidth”.
Semitone •
-48 to +48 semitones: The nominal pitch of oscillator 1. Modulation destination “Osc1Pitch“.
Key Follow •
-64 to +31, Norm, +33 to +63: How much the pitch of oscillator 1 follows the keyboard (i.e. MIDI note
number). Press both VALUE buttons at the same time for normal tuning (Norm).
Balance •
-64 to +63: Adjusts the relative levels of oscillator 1 and oscillator 2 (including FM), whereby -64 is oscillator
1 only and +63 is oscillator 2 only. Note that this parameter is mirrored in the oscillator 2 menu. Modulation
destination “OscBalance”.
Comentarios a estos manuales