Access VIRUS CLASSIC Especificaciones descargar pdf (Pagina 44)

42 CHAPTER 4

Introduction



LFO 1

Start with the usual basic sound conﬁgu-

ration or chose a modiﬁed sound to suit

your taste. Locate the RATE encoder in

the LFO 1 section of the control panel.

The VIRUS is equipped with an LED that

indicates the speed of the LFO as well as

its waveshape. Turn the RATE encoder

and check out how the ﬂash of the LED

indicates the change of pace as you

rotate the encoder.

Currently you are unable to hear the

effect of the LFO as its modulation inten-

sity is set to 0 in the sound program. In

order to change this setting, you must

access the ﬁve parameters called LFO

AMOUNT button which works with the

modulation destinations Oscillator1,

Oscillator2, PulseWidth1+2,

Resonance1+2 und FilterGain:



The modulation targets

 OSCILLATOR1 refers to the frequency

of oscillator 1

 OSCILLATOR2 refers to the frequency

of oscillator 2

 PULSEWIDTH1+2 means that the

pulse widths of both oscillators are

controlled in unison

 RESONANCE1+2 refers to the reso-

nances of both ﬁlters. Please keep in

mind that although each set of these

parameters is assigned a common

modulation intensity, you can still dial

in different sound-shaping settings

manually. In other words, the audible

result of a joint modulation varies

according to the values you have

determined for the other parameters.

 FILTERGAIN This term refers to the

input level of the ﬁrst ﬁlter (and of

course the subsequent saturation

level) - although WITHOUT THE LEVEL

COMPENSATION CONTROLLED VIA

OSC VOL. Here you can actually modu-

late a parameter that is not manually

accessible. The effect of a FiltGain

modulation is a periodic change in the

saturation level which is linked to a

corresponding tremolo (periodic

change in volume). If the signal is not

saturated in any manner, then the only

audible result is a tremolo effect.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 226 227

Comentarios a estos manuales

Sin comentarios